1. Clean Surface
2. Tape Graphic
3. Remove Backing

4. Graphic Down
5. Rub Down
6. Remove Mask



Detailed Instructions and Trouble Shooting

1. Clean window (or other smooth surface) thoroughly. Make sure the surface is dry before proceeding.
2. Place graphic level on surface and tape to the surface with masking tape across the top, creating a hinge.
3. Flip graphic up and back, pull liner (backing) off, exposing adhesive. If you have a problem pulling the liner (backing) off, rub back of liner with drivers license or credit card. DO NOT pull the liner off from the FRONT, be sure graphic is FACE DOWN to remove liner!
4. Hold graphic tautly by the corners and flip back down so that adhesive is against the surface.
5. With firm pressure (use driver license or credit card), rub graphic area from center out to edges forcing all air out. Any air bubbles will disappear.
6. Wait a few minutes, then remove clear masking by pulling straight back, leaving graphic ONLY on window. If graphic comes off with mask, repeat Step 5 and wait 24 hours before removing mask.